Post a Comment On: Nate Miller's Tabletop Games

[Image]  I picked up a couple of these Matchbox "Rev Rigs" tanks today at Walmart.  I didn't like the wheels but I figured that I could convert them into hover tanks for my Hell Knights.  They are slightly chunkier than my light hover tank so I thought they would be good as medium hover tanks.

[Image]  I had to locate the screws that held the wheels and drive on so I could take the tank body off which was the only part I was looking to use.  There were four screws on the side of the drive part but I had to remove the tires to get at two of them.  After that I was able to pry the drive apart to get at the screws holding the tank body on.  This pretty much wrecked the drive part but at least I got some nice gears I can use for other projects from it.  I figured I would make the hover drive from cheap disposable razor handles exactly like I did on the other hover tank. 

[Image] The one really bad thing about this toy is that the turret doesn't turn.  It's fixed in place with screws and post and even when you remove those it doesn't turn because the hole on the body is smaller than the hole in the turret.  Makes you wonder why they even put a hole in the body.  On almost every tank toy or model I have ever seen the turret had a simple key attachment system that allowed it to turn and held it in place.  I have no idea why they didn't use that on this toy.  There is no way a kid could get the turret in his mouth so it isn't a choke hazard.  I'm planning on figuring out a way to make the turret turn.  I'm going to have to put a bottom in the body anyway so I think I can rig something that should work.  Also the pintel mounted gun is really ugly and huge.  I will likely switch that out with a better looking weapon.  I have some cheapo machine guns in mind that aren't that special but they look way better than that thing. 

I'm pretty happy with the toy over all though.  I think it will be no harder to put together than my other hover tank project way.  Each kit bash has it's own little issues.  Unfortunately it will probably be next week before I get to this project because I'm going to an SCA event over the weekend.