Post a Comment On: Fawcett Avenue Conscripts

[Image]Here's a Flak 88 for the Afrika Korps... as everybody knows, this was the ultimate anti-tank weapon when pressed into that role by the Germans, and they developed some very clever tactics with the 88 in the Western Desert. Obviously a must-have for a DAK table-top force.[Image]So clearly I needed to build and paint one... and there are several available. Rubicon makes one in 1/56, and there are various metal kits about in "28mm" scale as well. I chose the one from Perry Miniatures for several reasons: it was described as a "resin kit" of only six pieces (I still have trauma from the 1/48 Bandai 88), Perry make a metal crew for it, and I needed some other models from them anyway. Done![Image]However, while I'm happy with the result, the model itself didn't thrill me. First, it's 3D printed (in resin), not a cast resin model. This is OK I guess, but when paying top price for a kit (18 pounds sterling!) I don't want to deal with print lines and such. Second, it's freakin' tiny. And third, did I mention it cost 18 pounds and didn't come with crew?? But to be fair, I think the Rubicon one is comparable in price (about 21 pounds) and comes with carriage parts and an early-war European theatre crew, but there are over 200 parts in the kit, and I've BTDT. [Image]So I went with Perry, and it worked out OK, after straightening out the warped trails. I'm also patting myself on the back for magnetising the crewman seen above aiming the gun. I used 5mm magnets, one attached to the body of the gun and the other to the seat mount on the crew figure.[Image]Speaking of the crew, they're great - typical Perry stuff. Anatomy and faces are first-rate, but it should be noted that they're fairly slightly built to match the plastic DAK models; these aren't "heroic 28mm" figures by any means. You get 8 of 'em in the pack and a couple shell crates for 8 pounds, which is pretty good if you don't have to have them posted to you.[Image]Here's that gun aimer. You can just see the disc magnet at the left.[Image]And here's some beauty shots of the gun itself. In hindsight I maybe could've used a lighter yellow to paint it but it's weathered and done now. Not one step back!![Image]As I said earlier, the trails were a little warped and wouldn't straighten with hot water, so I had to screw around a bit with mounting it to the base - basically had to put a spacer in the middle and superglue the pads at the ends of the trails to the base, and clamp them down. It worked in the end, but was a royal pain.So I guess I would say that if I had to do it over, I'd order the gun from Rubicon, pocket the Rubicon crew, and get the DAK crew from Perry. Two hundred parts is a lot for this model, but you do get the carriage parts - the DAK was known to put these guns into action straight from the carriage, and that would look cool on the table. Anyway, it's done now and that's the main thing, I'm on to the rest of the infantry platoon and a Blitzkrieg Pzkpfw. III, watch for those soon.