Post a Comment On: Arcade and Video Game Modding

Hey,

 I`ve started the plans and layout for a bartop ages ago. Finally I`ve started to produce the prototype. It was great to the finished parts :) I`ve decided on white wood with a modular design with countersunk bags. Due to that it`s clear which parts should assembled where and it`s possible to build the enclosure less than one hour. The design is based on the famous weecade. Thanks for that.

[Image]  Full set of parts

[Image]  Frontpanel with two 24mm holes. two neutrik USB plugs can  here assembled as well. The part below is for the back wand.

[Image] Acryl monitor bezel 3mm and  2mm strong. The artwork can be assmebled like a sandwich.
[Image]  Monitor VESA mount 75mm and 100mm holes. Two additional mounts will be glued.

[Image]  Top plate
[Image]  Speaker Panel
[Image]  Side with parts like feet, edge stuff, screws and bars.
[Image]
[Image]  The side have to different bags. One with 2mm for the bars. And one with 6mm for plugging the sheets.

[Image]  White lacquered aluminium and 2mm strong acryl.
[Image]  The front edge of the acryl is countersunk and polished.


[Image]  Marquee Plexi
[Image]

 The back panel has cuts for two fans, PSU Plug, on and off switch and two additioanl USB Plugs.
[Image]  Parts...
[Image]

 Back sheet with countersunk hole for a lock.
[Image] Bottom.